Note
Battery will be warm during charging and for some time thereafter.
Battery will run out if not used for long periods of time, even after being charged.
Battery can be topped up even if not fully depleted.
Do not disassemble or modify the charger.
Please purchase a new battery if battery life becomes significantly reduced.
Approximate battery life
Number of pictures:
270 [300
2
] (at 30-sec intervals)
1
(equivalent to approx. 135 [150
2
] mins)
1
Values based on CIPA standards. (P.91)
(Number reduced if intervals longer – 67 [75
2
] pictures if 2-minute intervals)
Playback time: Approx. 260 [280
2
] mins
Above figures may be reduced if intervals between recording are longer; if flash, zoom,
or POWER LCD are used frequently; or in colder climates (depends on actual usage).
2
DMC-TZ2
Battery (model-specific)
Charger
(model-specific)
Indoor electrical outlet
(charge at room temperature of 10-
35°C (50°F-95°F))
Connect to charger.
(Ensure ‘LUMIX’ faces outwards.)
Fold out pins and
plug into electrical outlet.
Disconnect charger and
battery when charging is
complete.
Charging light (CHARGE)
On: Charging in progress (approx. 120 min.)
Off: Charging complete
If light is flashing…
● Battery temperature is too high/too low → Battery may still be charged, but it will
take longer as it must adjust to the room temperature.
● Battery/charger connector is dirty → clean with dry cloth.
plug
To Next Page
Loading...
Need help?
General
