EasyManuals Logo

Panasonic Lumix DMC-TZ3 User Manual

Panasonic Lumix DMC-TZ3
108 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #86 background imageLoading...
Page #86 background image
86 VQT1B61
Others
3
Q&A Troubleshooting (Continued)
Recording (continued)
Recorded pictures appear coarse, or there is interference.
ISO sensitivity is high, or shutter speed is low.
(Default SENSITIVITY setting is ‘AUTO’ – interference may appear with indoor
pictures.)
Lower ‘SENSITIVITY’ (P.51).
Set ‘COL. MODE’ to ‘NATURAL (P.57)
Take pictures in brighter locations.
Camera set to ‘HIGH SENS.’ scene mode (P.44).
(Picture becomes slightly coarser in response to high sensitivity)
Brightness or coloring of recorded picture different from real life.
Taking pictures under fluorescent lighting may require a faster shutter speed and
result in slightly changed brightness or coloring, but this is not a fault.
Reddish vertical line (smear) appears during recording.
This is a characteristic of CCD and may appear if subject contains
brighter areas. Some blurring may occur around these areas, but this is
not a fault.
(This will be recorded in motion pictures, but not in still pictures.)
Motion picture recording stops midway.
Using MultiMediaCard (not compatible with motion picture recording).
‘PICT. MODE’ set to ‘30fps VGA or ‘30fps 16:9’ (P.47).
Use a card of at least 10MB/s (as marked on packaging, etc).
With some cards, access display may appear briefly after recording, and recording
may end midway.
LCD monitor
Monitor sometimes shuts off even though power is on.
Camera set to ‘ECONOMY’ (P.20).
(LCD monitor shuts off during flash recharging)
After recording, monitor shuts off until next picture can be recorded.
(Maximum built-in memory usage approx. 6 sec)
Brightness is unstable.
Aperture value is set while shutter button is pressed halfway.
(Does not affect recorded picture.)
Monitor flickers indoors.
Monitor may flicker after turning on (prevents influence from fluorescent lighting).
Monitor is too bright/too dark.
Adjust LCD monitor brightness (P.20).
Camera set to ‘POWER LCD’ or ‘HIGH ANGLE’ (P.34).
Monitor may darken when internal temperature is low. Monitor will brighten again
when temperature rises.
Black/blue/red/green dots or interference appears. Monitor looks distorted when
touched.
This is not a fault, and will not be recorded on the actual pictures, so there is no need
to worry.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Panasonic Lumix DMC-TZ3 and is the answer not in the manual?

Panasonic Lumix DMC-TZ3 Specifications

General IconGeneral
Sensor Resolution7.2 megapixels
Optical Zoom10x
LCD Screen Size3.0 inches
Image StabilizationOptical
ISO Sensitivity100 - 1250
Battery TypeLithium-Ion Battery Pack
TypeCompact
Digital Zoom4x
Shutter Speed8 - 1/2000 sec
Dimensions105 x 59.2 x 36.7 mm
Video Recording848 x 480 at 30 fps
Weight232 g
Focal Length4.6-46 mm (28-280 mm equivalent)
Maximum Aperturef/3.3 - f/4.9
Storage MediaSD, SDHC, MMC
Image Sensor Size1/2.35 inch

Related product manuals