VQT1B61 89
Others
Menu not displayed in desired language.
Change ‘LANGUAGE’ setting (P.22).
Camera rattles if shaken.
This sound is made by the lens movement and is not a fault.
Cannot set ‘AUTO REVIEW’.
Cannot be set when any of the following are in use: ‘AUTO BRACKET’ (DMC-TZ3
only) (P.38), ‘BURST’ (P.54), ‘SELF PORTRAIT’ scene mode (P.42), MOTION
PICTURE mode (P.47), or ‘AUDIO REC.’ (P.53).
Red lamp illuminated when pressing shutter button halfway in dark locations.
‘AF ASSIST LAMP’ set to ‘ON’ (P.56).
AF ASSIST LAMP is not illuminated.
‘AF ASSIST LAMP’ is set to ‘OFF’ (P.56).
Not illuminated in bright locations or when using ‘SCENERY’, ‘NIGHT SCENERY’,
‘SELF PORTRAIT’ (P.42), ‘FIREWORKS’, or ‘AERIAL PHOTO’ (P.44) scene modes.
Camera is hot.
Camera may become a little warm during use, but this does not affect performance or
quality.
Lens makes a clicking noise.
When brightness changes, the lens may make a clicking noise and the monitor
brightness may also change, but this is due to aperture settings being made.
(Does not affect recording.)
Clock is incorrect.
Camera has been left for a long period.
→ Reset the clock (P.16).
(Date will be set to ‘0:00 0. 0. 0’ for pictures if clock is not set.)
Long time was taken to set clock (clock behind by this amount).
When using zoom, picture becomes slightly warped and the edges of the subject
become colored.
Pictures may be slightly warped or colored around the edges, depending on the zoom
ratio, but this is not a fault (P.27).
File numbers are not recorded in sequence.
File numbers are reset when new folders are created (P.75).
File numbers have jumped backwards.
Battery was removed/inserted with power on.
(Numbers may jump backwards if folder/file numbers are not correctly recorded.)
To Next Page
Loading...
Need help?
General
