Panasonic LUMIX GH5 II - Page 270

7. Metering/Exposure/ISO Sensitivity – Exposure Compensation
270
3
Confirm your selection.
≥Press the shutter button halfway.
• In [M] mode, you can compensate the exposure by setting the ISO sensitivity to
[AUTO].
• When the exposure compensation value falls below or exceeds n3 EV, the
brightness of the recording screen will no longer change.
Press the shutter button halfway or use AE Lock to reflect the value on the
recording screen.
• The set exposure compensation value is stored even if you turn off the camera.
• The standard value for standard exposure can be adjusted:
[]  [ ]  [Exposure Offset Adjust.] ([Exposure Offset Adjust.]: 550)
• You can set the exposure compensation value to be reset when the camera is
turned off:
[]  [ ]  [Exposure Comp. Reset] ([Exposure Comp. Reset]: 551)
• You can change the operation of the [ ] button:
[]  [ ]  [WB/ISO/Expo. Button] ([WB/ISO/Expo. Button]: 561)
• Exposure Bracket can be set and flash output can be adjusted on the exposure
compensation screen:
[]  [ ]  [Exposure Comp. Disp. Setting] ([Exposure Comp. Disp.
Setting]: 561)