16. Streaming Function – Stream by Operating the Camera
680
3 Input the streaming destination (URL, stream key) to “LUMIX Network
Setting Software” and select [Next].
4 Set the output destination (card) and file name, and select [Save].
• Characters that can be set in [File Name]: Alphabet (uppercase),
numbers, up to 8 characters.
• To prevent usage from a third party, you can secure the streaming
destination with a password.
– Put a check mark in [Password].
– When you set a password, password input will be required when
loading the streaming destination.
– You can enter any 4-digit numbers as the password.
• The settings set at step 3 is saved in the card.
(Camera operation)
2
Insert a card to the camera.
3
Set up streaming settings on the camera.
1 Set the mode dial to [ ].
2 Load the streaming destination to the camera.
• [ ] [ ] [Wi-Fi] [Streaming Setup] [Save/Load
Streaming Address] [Load]
• If a password is set at step 1, input the password.
3 Set the streaming quality and wireless access point to connect to.
• [ ] [ ] [Wi-Fi] [Streaming Setup] [Streaming
Quality]/[Wi-Fi Connection Setting] (Streaming Settings: 682)
4 Set [Streaming Function] to [ON].
• [ ] [ ] [Wi-Fi] [Streaming Setup] [Streaming
Function] [ON]
• If the message [Unable to confirm security of the streaming address.
Continue?] is displayed, check that the URL of the streaming destination
is correct before continuing the connecting operation.
• The camera connects to the access point via Wi-Fi.
• [ ] is displayed on the recording screen.
To Next Page
Loading...
Need help?
General
