42
TC IN / OUT 3 / 3
Maintaining the Slave State
Even if you disconnect the BNC cable, the camera will remain in slave state.
Releasing the Slave State
Perform one of the following operations to release the camera from the slave state.
– Operate the camera ON/OFF switch.
– Switch the recording mode.
– Change the [ System Frequency ].
– Set the [ Variable Frame Rate ].
– Switch the [Rec Quality] between 47.95p/23.98p and a different recording frame rate.
– Change the following [ Time Code ] setting items
[ Count Up ], [ Time Code Value ], [ Time Code Mode ], [ TC Synchronization ].
Restoring the Slave State
To restore the slave state, reconnect the BNC cable to the external device while set as
follows. The time code signal (LTC signal) can be input just by connecting.
– [ ] mode
– [ Count Up ] : [ Free Run ]
– [ TC Synchronization ] : [ TC IN ]
Even when the system frequency differs between the camera and the external device,
their initial time code values may be synchronized.
Bear in mind, however, that the time codes lose sync as they count up.
3. HDMI Output and TC IN/OUT
To Next Page
Loading...
