Panasonic NA-148VS4 - Preset Timer; Child Safety Lock; Setting The Buzzer

Washing Instructions - 23
Optional Functions
Preset timer
Timefunctionisavailabletopresetthetime
fortheprogrammetofinish.
- YoucannotpresettheWoolprogramme.
- Thewashmayfinishbeforeorafter
presettimedependingonthekindof
laundry,thetemperatureandconditions
ofwatersupplyanddrainage.
NOTE
DoNOTusedetergentwhichdoesnot
dissolvethoroughlywiththepreset
functionbecausethedetergentmay
cakeupbeforethewashstartsand
doesnotflowout.
Setting a preset time
PressandholdtheTimebuttonuntilthe
desiredpresettimeisdisplayed.
Changing a preset time
1. Press the Off button and then press
the On button.
2. Choose the desired programme and
optional functions.
3. Set a preset time.
Cancelling a preset time
PresstheOffbutton.(Allsettingswillbe
cancelled.)
Checking a preset time
PresstheTimebutton.
Child safety lock
Thechildsafetylockpreventschildrenfrom
climbingintothedrumandgettingtrapped.
Thisfunctionkeepsthedoorclosedand
lockedevenwhentheapplianceisnotin
use.Italsodisablesthecontrolbuttons.
Activating/deactivating child safety lock
1. Switch on the appliance.
2. Press and hold the Mode button for at
least 5 seconds.
TheABsymbolslightuptoshowthat
thechildsafetylockisactivated.
3. To deactivate, hold down the Mode
button again for 5 seconds (please
ignore three beeps heard), and keep
Mode button pressed until it unlocks.
Setting the buzzer
Thebuzzerthatsoundswhena
programmefinishescanbeturnedoff.
1. Press the Start and On buttons at the
same time.
2. Release the On button and keep
pressing the Start button for
3 seconds. The buzzer setting will be
turned off after a beep is heard.
Ifyouwishtoresetthesetting,perform
thesamesteps1and2.Thebuzzer
settingwillbeturnedonaftertwobeeps
areheard.
NA-140_148VS4_AUNZ_EN_20140213.indb 23 2014/02/13 13:35:38