Panasonic NA-148VS4 - Moving And Installing; Removing The Anchor Bolts; Moving The Appliance

34 - Installation Instructions
Moving and Installing
Removing the anchor bolts
Fouranchorboltskeeptheinteriorofthe
applianceinplacewhiletheappliance
isbeingmoved.Removethembefore
installation,usingthespannersupplied
withtheappliance.Followtheinstructions
below.
NOTE
Theanchorboltsmustberemoved
beforetheapplianceisoperated.
Theymaycauseexcessivevibration.
1. Use the ‘B’ end of the spanner to
loosen the four bolts.
B
B
A
2. Pull the bolts out horizontally.
3. Remove the screws adjacent to the
bolt holes.
4. Attach each cover cap (included
with the accessories) over each bolt
hole, and then secure them with the
screws removed in step 3.
NOTE
- Makesurethatyoustoretheanchor
boltsbecausetheyareusedwhen
transportingtheappliance.Ifthe
applianceispassedontoanother
person,makesuretogivetheanchor
boltstothatperson.
- Makesuretheboltcapsare
attached.Failuretoobservethismay
resultinwaterenteringthewashing
machine,leadingtomalfunctions.
Moving the appliance
NOTE
Makesuretoinstalltheanchorboltsin
theappliance.
Before you move the appliance
- Shutthetapandruntheapplianceto
drainthewater.Drainremainingwater
fromthepumphose.(Seepage25.)
- Depressurizeandremovethewater
supplyhose.
- Disconnectthepowercable.
- Installtheanchorbolts.(Seepage35.)
NA-140_148VS4_AUNZ_EN_20140213.indb 34 2014/02/13 13:35:41