Panasonic NA-148VS4 - Cleaning The Water Supply Filter; Preventing a Frozen Water Supply Hose

26 - Maintenance
Maintenance
Cleaning the water supply
filter
Cleanthefilterifwaterisnotsupplied
properly.
1. Turn off the tap.
2. Switch on the appliance.
3. Select the Cotton programme, and
then press the Start button.
4. After 1 minute, switch off the
appliance. Water has drained out of
the water supply hose.
5. Disconnect the water supply hose
from the appliance.
6. Clean the filter, which is on the rear
of the appliance.
Useasmallbrush,forexample,a
toothbrush.
7. If the unit is supplied with the hose
fitted with a water supply valve, turn
off the tap supplying water to the
appliance, disconnect the hose from
the tap and then clean the filter on
the hose in the same way.
8. Reconnect the water supply hose.
Tightentheplasticjointfirmly.
9. Turn on the tap and then check for
leaks.
Preventing a frozen water
supply hose
Iftheapplianceisdeliveredinfreezing
weatherconditions,aftersettingup,leave
itatroomtemperaturefor24hoursbefore
using.Thiswillensurethatthewatersupply
hosedoesnotbecomecloggedwithice.
Ifyourwatersupplyhosefreezes,perform
thefollowingprocedures:
1. Wrap warm towels around the joints
of the water supply hose.
Joints
Watersupplyhose
2. Add 2 to 3 litres of warm water to the
drum.
approximately
50°C
3. Start washing with the Drain only
function, using the Mode button.
(Seepage22.)
NA-140_148VS4_AUNZ_EN_20140213.indb 26 2014/02/13 13:35:39