Panasonic NA-148VS4 - Troubleshooting; Fault Checklist

Troubleshooting - 31
Error Display
Unable to drain
What to do
Checkthedrainhoseforanyofthefollowingproblems.
- Itclogsup.
- Itstipisimmersedinwater.
- Itextendsfurtherthan3m.
- Thewaterisfrozen.
Cleanthedrainfilterifitclogsup.(Seepage25.)
Aftercorrectingtheproblem,openandclosethedoor,andthen
startthewashagain.
Door is open
What to do
Makesurethatthedoorisshutproperly.
Unable to spin-dry
Theappliancehasbeendesignedtodetectunbalancedloads,
particularlysmallloads,inordertoensurequietoperationand
achievethebestresults.
Thisisnotamalfunction.Performanyofthefollowingsolutions.
What to do
- Ifthelaundryistooheavy,untangleclumpsofclothing.
- Ifthelaundrysuchasablanketistooheavy,reducetheload.
- Ifthelaundryistoolight,addoneortwobathtowels.
- Iftheapplianceisonanunstableorunevensurface,change
thesettinglocation.
Aftercorrectingtheproblem,openandclosethedoor,andthen
startthewashagain.
Unable to supply
water
What to do
Checkforanyofthefollowingproblems.
- Thetapisclosed.
- Thewaterpipeorhoseisfrozen.
- Thewatersupplyhasbeendisrupted.
- Thewatersupplyfilterisclogged.(Seepage26.)
Aftercorrectingtheproblem,openandclosethedoor,andthen
startthewashagain.
Iftheredmarkappearsinthehosewithawatersupplyvalve,the
watersupplyhasstopped.
Youshouldreplacewithanewhose.
Hosewithwatersupplyvalve(AXW12C-7SR0)
AnerrordisplaystartingwithH.
What to do
PresstheOffbutton.Ifthedisplaystayson,orifitreappears
whenyoupresstheStartbutton,unplugtheapplianceand
contactyourlocalCustomerServiceCentre.
NA-140_148VS4_AUNZ_EN_20140213.indb 31 2014/02/13 13:35:40