Panasonic NA-148VS4 - Installation Instructions; Selecting the Installation Location

36 - Installation Instructions
Connecting Hoses and Power Supply
Water supply hose
CAUTION
- Do NOT connect the water supply
hose to a combination tap.
- Do NOT twist, squash, modify or
cut the hose.
- Optimummainswaterpressureis
0.03-1.0MPa.Ifthewaterpressure
exceedsthisvalue,installapressure
reducingvalve.
- Waterflowfromthetapshouldbemore
than5L/min.
Connecting the water supply hose
1. Attach one end of the hose to
the water inlet on the back of the
appliance and tighten the joint by
hand.
2. Attach the other end of the hose to
the tap and tighten it the same way.
min.10mm
min.10mm
3/4”
3/4”
Hosewithwater
supplyvalve
Standardhose
3. Open the tap slowly and make sure
that there are no leaks around the
joints.
Thejointsaresubjecttowaterpressure.
Followtheinstructionsinthissectiontopreventwaterleaks.Ifyouareunsure,askaservice
agenttoconnectthehoses.
Hoses and cable lengths
Leftsideconnections Rightsideconnections
~105cm ~135cm
~130cm ~90cm
~100cm ~140cm
0–max.100cm
NA-140_148VS4_AUNZ_EN_20140213.indb 36 2014/02/13 13:35:42