Panasonic NA-148VS4 - Moving and Installing the Machine

38 - Installation Instructions
Checking after Installation
Test run after installation
Checkforwaterleakage,abnormalnoise,
andproperdrainage.
Performthefollowingprocedures
WITHOUTlaundryinthedrum.
1. Turn on the tap.
2. Close the door.
3. Press the On button. You have to select
“Quick 50” course and “Spin only” mode.
Then, press the Start button.
After the water is drained, start a test run.
4. While holding down the Speed/Eco
and Easy Ironing buttons, press the
On button.
5. When the display appears as below
(3 seconds), press the Speed/Eco button.
Theremainingtimeisdisplayedasshownbelow.
Thetestisrunforapproximately3minutes.
- Whenthewaterpressureislow,the
operationmaystopforseveralminutes
with“0:03”displayed.
Checkthefollowing:
- Isthereanyabnormalnoise?
Ifso,makesurethattheapplianceislevel.
- Isthereanywaterleakage?
Ifso,makesurethatthehosesare
properlyconnected.
Thefollowingerrorsmayoccur:
- Arethehosesproperlyconnected?
Isthedrainclogged?
- Haveyouproperlyconnectedthe
watersupplyhoseandturnedonthetap?
Aftertheappliancehasrecoveredfromanerror,
reopenandreclosethedoortoresumethetest.
Installation checklist
7
1
5 6 5 6
3
2
4
65
1)Anchorbolts
Haveyouremovedthemandattached
thecovercapsproperly?
2)Location
Istheapplianceonaflat,stable
surface?
Doesitrunwithoutvibrating?
3)Watersupplyhose
Isitfreefromleaks?
Isthewatersupplynormal?
4)Waterdrainhose
Isitfreefromleaks?
Doesitdrainnormally?
5)Adjustablestands
Aretheyboltedsecurelytothe
appliance?
6)Standcushions
Aretheystandingflat?
Iftheapplianceisnotlevel,theremay
beabnormalsoundswhenwateris
drainedout.
7)Powersupply
Isthehouseholddedicatedmainssocket
fullyratedatAC220Vto240V?
NA-140_148VS4_AUNZ_EN_20140213.indb 38 2014/02/13 13:35:44