EasyManua.ls Logo

Panasonic NA-148XR1 - Maintenance; Water Supply Filter Cleaning

Panasonic NA-148XR1
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
28 2929
Optional FunctionsMaintenance
Cancelling the buzzer
You can turn off the buzzer that
sounds at the end of the programme.
1
Turn on the power.
2
Press at same time, for about
5 seconds.
The buzzer setting is cancelled
after a beep.
To activate
Do the same operation as you did
for cancelling. The buzzer setting is
activated after two beeps.
Setting the Child Lock
You can lock the door to prevent
children from opening it themselves.
This also locks the operation buttons.
1
Turn on the power.
2
Press for at least
5 seconds.
Lights up
To deactivate
Press for at least
5 seconds.
( disappears.)
zIgnore the beeps and keep
“Mode” pressed until the Child
Lock is deactivated.
Changing Appliance Settings Maintenance
Water supply lter
Clean the lter if water is not supplied 
properly.
Water supply lter
1 Turn off the tap.
2 Turn on the power and start the
“Cotton” programme without any
laundry or detergent inside the
drum. (P. 17)
3 After 1 minute, turn off the power.
Water has drained out of the water
supply hose.
4 Remove the water supply hose and
clean the water supply lter.
Water supply
lter
Brush etc.
If the hose is tted with a water
supply valve
Also remove the hose from the tap
and clean the water supply lter at 
that end too.
Hose with water
supply valve tted
Filter
If the water supply hose is frozen
1 Wrap warm towels around the joints
of the water supply hose.
Joints
Water
supply hose
2 Put 2 to 3 litres of hot water (about
50 °C) into the drum.
3 Select in “Mode” (P. 26), and
start operation.
NOTE
zIf the appliance is delivered in
freezing weather conditions, leave
it indoors for about 24 hours before
using it. This will allow any ice
inside the hose to melt.

Related product manuals