38 3939
Installation
Service person only
Moving and Installing
Levelling the appliance
Prepare a No.17 spanner. (sold
separately)
4 adjustable feet
(1) (2)
(4)
(3)
Lock nut
Adjustable feet
1
2
3
1 Loosen the lock nut with the
spanner.
2 Turn the adjustable foot to adjust
the height.
3 Tighten the lock nut. (A spirit
level is useful for making sure the
appliance is level.)
NOTE
zMake sure that all lock nuts
are tightened securely and the
adjustable feet are still bolted to the
appliance.
If they are unbolted, the appliance
will shake and move around.
The anchor rods keep the interior of
the appliance in place, and protect it
from vibration during transportation.
Drum
Anchor
rods
NOTE
zOperating the appliance with
anchor rods still attached will cause
excessive vibration. They must be
removed before operation.
zStore the anchor rods and brackets.
They will be needed when the
appliance is moved again in the
future.
zWhen moving the appliance again,
the anchor rods and brackets must
be attached to the appliance. Attach
the anchor rods in the reverse
order they were removed. If having
dif culty on positioning the anchor
rods, try the following:
- Insert the anchor rod while turning
it.
- Insert and position two anchor
rods in parallel at the same time.
- Insert the anchor rod while moving
the drum a little.
How to remove
Anchor
rods (2)
1 Remove two screws.
(Rear of appliance)
2 Remove the bracket.
3 Set the bracket to the groove of the
anchor rod, and turn 90 degrees.
4 Pull the anchor rod out.
The rod stops twice during removal.
Pull the rod while turning it.
5 Attach the cover cap to the hole. If
the caps are not attached, foreign
objects may enter the appliance
and cause a malfunction.
Removing the anchor rods
To Next Page
Loading...
