42 4343
Installation
Service person only
Checking after Installation
Appliance parts checklist
Anchor rods
zHave you removed all 2 anchor
rods and tted cover caps?
(P. 38, 39)
Mains plug £
zIs the appliance plugged into an
AC 220-240 V household mains
socket? (see back cover)
Test run
6 3, 7745 108 9
1
Turn on the tap.
2
Close the door without any
laundry in the drum.
3
Switch on the appliance.
4
Select the “Quick 50”
programme.
5
Select .
6
Start operation.
7
Switch the appliance
off and on.
8
Select .
9
Press for about
5 seconds.
is displayed.
10
Press while is
displayed to start test run.
is displayed.
......
u
Operation nishes after about
3 minutes.
Water leaks £
zCheck the appliance and hose
joints for leaks. (P. 40)
Abnormal noise £
zMake sure the appliance is level.
(P. 39)
Error display £
Unable to drain (P. 36)
Unable to supply water
(P. 36)
zAfter resolving an error, open
and close the door and press
“Start/Pause” to resume the test.
Adjustable feet £
zAre they stable and securely
tightened? (P. 39)
zIs the appliance level? (P. 39)
Water supply hose £
zIs the water supply hose
properly connected? Is it free
from leaks? (P. 41)
Installation place £
zIs the appliance on a at, stable
surface?
zDoes it run without vibrating?
(P. 39)
Drain hose £
zIs the drain hose properly
connected? Does it drain
normally? (P. 41)
Water supply
hose
Drain hose
Mains plug
Anchor rods (2)
Adjustable
feet (4)
Do not remove the fastener of the
drain hose in the upper left.
To Next Page
Loading...
