1) Lay down the washing machine.
2) Remove the bottom plate A.
3) Check condition of the lead wire holders
(wire type).
Lead wire holder
Lead wire holder
4) Remove the lead wire holder (2portions). 5) Fix the lead wire holder (insulock block type)
on to the isolating tape portion temporarily.
6) Insert the lead wire holder (insulock block
type) in to the motor cover B from left side.
7) Clamp and fix the lead wire holder (insulock
block type) to the motor cover B, and cut the
surplus portion of the lead wire holder by pliers.
Motor cover B
Insert from left
-39-
NA-168VX2/168VG2/148VA2/128VA2/147VB2
To Next Page
Loading...
