Panasonic NA-F100A2

12.2 H-Error indication
● If there is an operation error or if there is a problem with the washing machine,
- All the switchs cannot be operated.
- An error indication will be displayed.
- 18 -
Indication
Content Check Point Method to clear
H01
Water level sensor
error
Check at condition of the connector
Disconnect the power
plug--->plug in
Replace the Pressure sensor switch
Replace PCB board
H02
Motor triac error
In water drain action check both side of
Disconnect the power
plug--->plug in
capacitor that voltage not equal to “0” V.
Replace PCB board
H04
Load relay short
error
After turn on the Motor for 2 seconds,
capacitor voltage is not “0”
Change Capacitor
H05
The memory circuit
of IC error
Replace PCB board
Disconnect the power
plug--->plug in
H12
Safety switch
connection error
Replace Safety switch
Disconnect the power
plug--->plug in
H17
Thermistor error
(for X series)
Replace PCB board
Disconnect the power
plug--->plug in
H21
Overflow error
Check Feed valve and PCB
Disconnect the power
plug--->plug in
Replace Feed valve
Service NA-F100A2.indd 18Service NA-F100A2.indd 18 4/26/2559 BE 11:50 AM4/26/2559 BE 11:50 AM