– 36 – – 37 –
Sensor Reheat Programs Sensor Reheat Programs (continued)
This unique feature ‘the Genius’ built in sensor allows you to reheat a chilled meal with one push of the Dial. It
is not necessary to select the power level or cooking time. The built-in sensor measures the humidity of the food
and calculates the microwave power level together with a cooking time.
When clock or colon is displayed,
press the Dial to start.
To reset oven and return to clock or
colon, tap Stop/Cancel pad.
* Recommend weight range
Program
Weight*/
Placement
Instructions
Reheat a fresh
pre-cooked
chilled meal
200 - 1000
g
Base of oven
To reheat a chilled pre-cooked meal. All foods must be pre-cooked
and at refrigerator temperature approx. +5 °C. Reheat in container as
purchased. Pierce covering film with a sharp knife once in the center
and four times around the edge. If transferring food to dish, cover with
pierced cling film. Place container on base of oven. Press Dial to start
the program. Stir at beeps. Stir again at end of program and allow a few
minutes standing time. Large pieces of meat/fish in a thin sauce may
require longer cooking. This program is not suitable for starchy food such
as rice, noodles or potatoes. Meals in irregular bowl shaped containers
may need longer cooking.
One Push Reheating
NO.1 FROZEN MEAL
Note:
Press the Dial in two minutes right after the door was closed, otherwise One Push Reheating Function will be
rejected and beeps will sound. Open the door and close it again will release the One Push Reheating Function.
This unique feature allows you to simply reheat a frozen meal. It is not necessary to select the power level,
weight or cooking time. The built-in sensor measures the humidity of the food and calculates the microwave
power level together with a cooking time.
* Recommend weight range
No. Program
Weight*/
Placement
Instructions
1
FROZEN
MEAL
200 - 1000
g
Base of oven
To reheat a frozen pre-cooked meal. All foods must be pre-cooked
and frozen (-18 °C). Reheat in container as purchased. Pierce
covering film with a sharp knife once in the center and four times
around the edge. If transferring food to dish, cover with pierced cling
film. Place container on base of oven. Select program number 1. Start
to cook. Stir at beeps and cut any blocks into pieces. Stir again at end
of program and allow a few minutes standing time. Large pieces of
meat/fish in a thin sauce may require longer cooking. This program is
not suitable for starchy food such as rice, noodles or potatoes. Meals
in irregular bowl shaped containers may need longer cooking.
1
Tap once.
2
Press the Dial to confirm the program.
3
Press the Dial to start.
Adjust to Taste
The Sensor Reheat Program reheats a chilled meal or a frozen meal for average tastes. You are able to
adjust the Sensor Reheat Program to your own taste. After pressing the Dial, "
/ "symbol appears in the
display,turn Dial clockwise for more time or anticlockwise for less time. This operation should be completed
within 14 seconds. Default mode is normal.
How it Works
Once the Sensor Reheat Program has been selected and the Dial is pressed the food is heating up. As food
begins to get hot, steam is emitted. When the food reaches a certain temperature and begins to cook, an even
greater amount of steam is released. The increase in steam emission is detected by a humidity sensor in the
oven. This acts as a signal for the oven to calculate how much longer the food needs to reheat. The remaining
cooking time will appear in the display window after two beeps. Whilst the sensor program is still in the display
window the oven door should not be opened. Wait until the cooking time appears in the window, and then open
the door if required, to stir or turn the food.
Notes:
1. This feature is not suitable for foods that cannot be stirred eg. lasagne / macaroni cheese.
2. The oven automatically calculates the reheating time or the remaining reheating time.
3. The door should not be opened before the time appears in the display window.
4. To prevent any mistakes during Sensor Reheat Programs ensure that base of oven and the container are dry.
5. The room temperature should not be more than 35 °C and not less than 0 °C.
6. If the oven has previously been used and it is too hot to be used on Sensor Reheat Programs, ‘HOT’ will
appear in the display window. After the ‘HOT’ disappears, the Sensor Reheat Programs may be used. If in a
hurry, cook food manually by selecting the correct cooking mode and cooking time yourself.
To Next Page
Loading...
