- Eng-55 -
English
Before Requesting Service
PROBLEM POSSIBLE CAUSE REMEDY
No display on panel.
Oven cannot start
operation.
No steam
“U12” appears in the
display window.
“U50” appears in the
display window.
The control panel has
no response on it.
There is a white powder
near the steam outlet.
“H55, H56, H00” appears
in the display window.
“U14” appears in the
display window.
If it seems there is a problem with the oven, contact an authorized Service Center.
The oven is not plugged in
securely.
Remove plug from outlet, wait 10 seconds
and re-insert.
Circuit breaker or fuse is tripped
or blown.
Reinstall the fuse or reset the Circuit
breaker.
There is a problem with the
outlet.
Plug another appliance into the outlet to
check if the outlet is working.
The door is not closed
completely.
Close the oven door securely.
“
” pad was not pressed after
programming.
Press “
” pad.
Another program has already
been entered into the oven.
Press “
” pad to cancel the previous
program and program again.
The program has not been
entered correctly.
Program again according to the Operating
Instructions.
“
” pad has been pressed
accidentally.
Program oven again.
Check whether the water tank
has water.
Fully fill the water tank and properly install
it.
Check whether the water tank is
installed correctly in place.
The water tank lacks water.
“U14” appears in the first two cooking,
you can press “
” pad to start cooking
directly. But if “U14” appear again, cooking
cannot be continued, please fill the water
tank again with water. Replace to the oven
and press “
” pad to reset again.
The drip tray is not installed
correctly in place or not installed
before cooking.
Reattach the bayonet of the drip tray to
the foot of the oven.
The drip tray is not installed
correctly in place or removed
when cooking.
Put the drip tray back to the oven within
3 minutes, cooking will not stop. After
3 minutes without putting back to the oven,
cooking can not be continued, please put
the drip tray back to the oven and press
“
” pad to resetting the cooking.
The cavity or room temperature
is overheated.
Operate again after cavity or room temperature
cooling down and “U50” disappears.
This oven is under standby
mode.
Confirm that when the power is on, open
and close the door to reactivate it.
No distilled water is used.
The white powder is scale. Please use the
citric acid cleaning function to clean water
supply lines.
There is a problem with the oven.
Please contact the specified Service Center.
F0003CE30HP_eng.indd 55F0003CE30HP_eng.indd 55 2018/8/20 18:01:282018/8/20 18:01:28
To Next Page
Loading...
