EasyManua.ls Logo

Panasonic NV-MX2 - Wind Noise Reduction and Video Flash; Wind Noise Reduction Function; Video Flash Operation and Settings

Panasonic NV-MX2
60 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
24
PUSH
1
2
4
STILL
3
PHOTO
SHOT
MENU
PUSH
W.B/SHUTTER/IRIS/
VOL/JOG
2
Wind Noise Reduction Function
This function reduces the sound of a wind hitting the microphone when
recording.
1
Set [CAMERA FUNCTIONS] >> [RECORDING SETUP] >>
[WIND CUT] >> [ON].
The [WIND CUT] Indication
1
appears.
It does not work with an external microphone.
When it is set to [ON], directivity of microphone is regulated depending on
the strength of wind to reduce wind noise.
~~~~~~~~~~~~~~~~~~~~~~~~
Using the Video Flash
The Built-in Video Flash enables you to record still pictures in a dark place.
The following is the steps to operate the Video Flash Function with the NV-
MX8. When using the optional Video Flash (VW-FLH3E), refer to the
operating instructions of the Video Flash.
1
Press the [PUSH] Button to open the Video Flash.
2
Set [FLASH] on the [RECORDING SETUP] Sub-Menu to [ON]
or [AUTO].
If [AUTO] is selected, Video Flash is set off if light is needed by sensing
the surrounding luminosity.
3
Press the [STILL] Button.
Video Flash is set off.
4
Press the [PHOTO SHOT] Button or Recording Start/Stop
Button.
Video Flash is not set off when recording.
If either [
ß
],
[
ß
i] or [
ß
j] indication is lit, flash is set off. If flashing or dark,
Video Flash is not set off.
The available range of the Video Flash is approximately 1 to 2.5 metres in a
dark places. Picture will appear dark when they are recorded by using the
Video Flash at distances greater than 2.5 metres.
Using the Video Flash VW-FLH3E(optional) enables you to record still
pictures farther than 2.5 metres in a dark place. The available range is
approximately 1 to 4 metres.
Video Flash VW-FLH3E(optional) and the built-in video flash cannot be
used simultaneously.
Object of recording may appear dark if flash is set off in front of white
background.
Tele Conversion Lens (VW-LW4307ME) or Wide Conversion Lens (VW-
LW4314ME) can block flash light and may cause vignetting effect.
Adjusting Brightness of the Video Flash
Brightness of the Video Flash can be set in [FLASH LEVEL] on the
[RECORDING SETUP] Sub-Menu.
Set [FLASH LEVEL] on the [RECORDING SETUP] Sub-Menu to desired
Flash Level.
Normally, set it to [NORMAL] ( [
ß
] indication appears).
If the brightness is not enough in [NORMAL] setting, set it to [i] ([
ß
i]
indication appears), if it is too much, set it to [j] ([
ß
j] indication appears).
To make the Red Eye phenomenon reduce
Set the [RED EYE REDUCTION] on the [RECORDING SETUP] Sub-Menu to
[ON].
The [£] indication appears.
You may get red eyes phenomenon depending on the recording condition.
For other notes concerning this item, see page 48.
1
WIND CUT
1
AUTO
MNL
PUSH
MENU
W.B/SHUTTER/IRIS/
VOL/JOG
B.book24ページ2001年8月27日 月曜日 午前10時14

Table of Contents

Related product manuals