Panasonic NV-MX2 - Getting Started; Battery and Cassette Setup; Powering On and Recording; Viewing Recorded Content

5
CAMERA
VCR
CARD.P.B
MODE
ON
OFF
4,5,6
OPEN/EJECT
1
2
3
6
4
1
3
,5,7
2
Getting Started
1
Charge the Battery.
(
l
10)
≥Attach the Battery to the AC Adaptor.
≥Connect the AC Mains Lead. (Charging starts.)
≥When the Charge Lamp [CHARGE] goes off, the Battery is fully
charged.
2
Attach the Charged Battery to the Movie Camera.
(
l
10)
3
Insert the Cassette.
(
l
11)
≥Slide the
1
Lever to the right and pull down to open the Cassette
Compartment Cover.
≥Insert the Cassette.
≥Press the [PUSH CLOSE] mark
2
to load the Cassette.
≥Close the Lower Compartment Cover.
4
Turn the Movie Camera on and start recording.
(
l
12, 18)
≥Set the
3
Switch to [ON]. (The [CAMERA] Lamp lights up.)
≥Press the
4
Button. (Recording starts.)
≥Press the
4
Button again to pause the recording.
Viewing What Has Been Recorded
5
Switch to the VCR Mode, rewind the tape, and play the tape
back. (
l
27)
≥Set the
5
Switch to [ON]. (The [VCR] Lamp lights up.)
≥Push the
6
Lever towards [6]. (Rewind the tape.)
≥Push the
6
Lever towards [1]. (Playback starts.)
≥Push the
6
Lever towards [∫]. (Playback stops.)
6
Turn the Movie Camera off.
(
l
12)
≥Set the
7
Switch to [OFF].
B.book5ページ２００１年８月２７日 月曜日 午前１０時１４分