PROG/CHECK
AV ENHANCER
21
Timer recording
Timer recording 1 / 3
Pos Date Start Stop
VPS
PDC
1 ARD 31/12 10:30 11:30 SP ON
1 ARD 31/12 11:30 12:30 SP ON
2 ZDF 31/12 12:30 13:30 SP ON
4 RTL 31/12 13:30 14:30 SP ON
6 VOX 31/12 14:30 15:30 SP ON
-- - - - - - -/ - - - -:- - - -:- - SP - - -
:select : store
: delete : exit
ENTER
CANCEL
EXIT
Timer recording 1 / 3
Pos Date Start Stop
VPS
PDC
1 ARD 31/12 10:30 11:30 SP ON
1 ARD 31/12 11:30 12:30 SP ON
2 ZDF 31/12 12:30 13:30 SP ON
4 RTL 31/12 13:30 14:30 SP ON
6 VOX 31/12 14:30 15:30 SP ON
-- - - - - - -/ - - - -:- - - -:- - SP - - -
: select : store
: delete : exit
ENTER
CANCEL
EXIT
The Timer recording allows you to programme the recording time of TV programmes
up to 1 month in advance. Use the on-screen menu to programme a maximum of 16
recordings.
Quitting the timer mode
!
Press TIMER, the VCR symbol will turn off.
You can now play back a cassette or make a manual recording. Press TIMER
again to reactivate the previously entered timer programme.
!
Press PROG/CHECK and select a free storage position .
!
Confirm with ENTER.
!
Select a station , and use to set date, week or weekday .
!
Then enter start- and stop-time , .
!
Hold buttons down to change time in 30-minute steps.
!
Select tape speed: A (Automatic), SP, LP, EP , .
!
The VPS/PDC settings may be changed with (does not apply to VP21).
!
Press ENTER to save timer programme.
!
Repeat these steps for further recordings you may wish to programme.
!
Press TIMER to activate the VCR´s timer mode.
Make sure the VCR symbol is displayed.
D
Do not forget to verify that there is enough tape left. The length of the recording
must not exceed the tape left on the video cassette.
To Next Page
Loading...
