VCR DISTORTIONS
!
Set Clock set to [AUTO] (not for VP21).
!
If the device cannot find a TV station transmitting the time signal, set Time and Date manually.
Automatic Clock set doesn’t work
properly:
!
The use of E-300 cassettes may cause problems if the recordings were taken at low tape speeds LP or EP
.
!
Check [PAL] and [MESECAM] settings.
!
Verify that the aerial and/or Scart cables are attached and work properly.
!
Check the SQPB/ S-VHS playback setting for S-VHS cassettes.
!
Faulty recordings taken at slow tape speed EP in [MESECAM] are not malfunctions.
!
Please contact your service technician if the video heads are dirty or worn out.
Having a technical service shop clean the video heads is not covered by the guarantee.
The recording functions do not
work properly:
!
If flashes on the device, check if the protection tab of the video cassette is still in.
!
Check Time and Date.
!
Check the start and stop time of the timer programme.
!
Check if the TIMER button has been pressed to put the device into timer mode after programming
a recording.
!
Check the start and stop time of a VPS/PDC recording. (not for VP21).
Bad picture or sound:
44
Before requesting service
!
If you notice interference or a shift of the picture during normal, still, or slow motion playback, press the
TRACKING / V-LOCK button towards + or - to correct the picture.
!
Press + and - together to activate automatic correction. Some video cassettes do not support tracking control.
This is not indicative of a malfunction.
Manual correction of a bad picture:
9
18
18
9
21
22
To Next Page
Loading...
