Panasonic NV-VX55A - Demonstration Mode

MIRROR
D.FADE 2
SOLARI
® ®
STROBE GAIN UP
® ®
BW
|
STDBY
MOTION SENSOR]
PANASONIC
88
@ Mirror Mode (-» 49)
@ Mix Mode (~ 50)
@ Wipe Mode (-» 51)
@ Strobe Mode (+ 52)
@ Gain up Mode (+ 53)
@ Nega Mode (> 53)
@ Solarisation Mode (-» 53)
@ Sepia Mode (+ 53)
@ Black-and-White Mode (~» 53)
@) Digital Fade 1 Mode (-» 54)
@® Digital Fade 2 Mode (-» 55)
@ Stand-by Condition in the Motion-Sensor-
Controlled Recording Mode (+ 56)
@ Demonstration Mode
Demonstration Mode
if you connect the AC Adaptor to the Movie Camera,
turn the Movie Camera on without any cassette
inserted, and leave it on for approximately 10 minutes
without performing any operation, it automatically
switches over to the Demonstration Mode. The Movie
Camera remains in this mode until you turn it off and
disconnect the AC Adaptor.
@ Cancelling the Demonstration Mode
Turn in the [POWER] Switch to turn the Movie Camera
off. Then turn it out again while pressing the [STOP}
Button.
@ Reactivating the Demonstration Mode
While pressing the [PLAY] Button, turn out the [POWER]
Switch. The Demonstration Mode starts after 6
seconds.