Panasonic Omnivision PV-7451 - On-Screen Displays (OSD); (Function, Channel, Menu, VCR Status & Clock, Warning)

On-Screen Displays (OSD)
Function & Channel Display
When a function button is
pushed, e.g. PLAY, or you
change channels, a 4 second
display appears first in large
and then small characters.
PLAY
Menu Screen
1 Push MENU to display
the menu.
2 Push AT and ► to
make your selection.
• To get the most from each feature, please read the
Operating Manual before attempting any operation.
MENU
IDIOMA/ LANGUE: ENGLI SH
SELECT:A ▼ KEY
SET > KEY
END MENU KEY
VCR Status & Clock Display
, D ISPLA Y
-Q
Push DISPLAY to display or
remove the overlay shown below.
Function Status
Current Time
Rec Time
Remaining —
(OTR mode only
see page 16.
REC
0:25
12:00AM CH08
0 : 0 0:00
SEP
(STEREO)*
Channel
Tape Speed
Broadcast Audio
Being Received
(See page 22.)
• This display will time
out in 5 seconds.
Counter
Blank Tape/ No Video Signal Indication
When a blank section of tape comes up in Play
mode, or the selected channel has no broadcast
signal, the TV screen will turn solid blue.
Warning and Instruction Displays
These displays will ale t you of a missed operation or
provide further instructions.
If no active channels are
found for CHANNEL
MEMORY...
(See page 12.)
If you attempt to set or
review a Timer Recording
and the Clock is not set...
(See page 18.)
After a Timer Program
has been set...
(See page 18.)
If you push REC on the
remote control or VCR,
and a cassette is inserted
with no record tab...
(See page 16.)
If you push PLAY, FF, REW,
or REC on the remote
control or VCR without
a cassette inserted...
(See pages 15,16.)
If you push POWER or
STOP during a Timer
Recording...
(visible in VCR mode only)
(See page 19.)
If head cleaning becomes
necessary while playing
back a tape...
(See page 5.)
NO CASSETTE
PLEASE INSERT A CASSETTE
TO CANCEL TIMER REC
PUSH POWER THEN STOP KEY
VIDEO HEADS MAY
NEED CLEANING
PLEASE INSERT HEAD
CLEANING CASSETTE
OR REFER TO MANUAL
END:PLAY KEY
- --
CHECK CASSETTE
RECORD TAB
«_-
PLEASE SET CLOCK
BEFORE PROGRAMMING
TURN VCR OFF
FOR TIMER RECORDING
NO CH FOUND
PLEASE CHECK ANTENNA
CABLE CONNECTION THEN
PUSH VCR CH UP KEY AGAIN
If you push a function button
other than STOP/EJECT or
POWER while the VCR is in
VCR Lock mode...
(See page 30.)
VCR LOCK ACTIVATED
14