Panasonic Omnivision PV-7451 - Timer Recording

Timer Recording
You can set up the VCR to record a one
time, daily, or weekly program while you
are away or otherwise occupied. Up to 8
programs can be stored in memory.
I^c
Check list before you begin.
□ All connections are made.
(See pages 6~9.)
□ TV and VCR are plugged in and turned on.
□ VCR/TV selector is set to “VCR."
□ Clock is set to correct time.
□ Record tab in place. (See page 5.)
Push PROG to display
the “SET PROGRAM”
screen.
▲ ' Push AT to select
“TIMER PROGRAM,”
and then push ► to
display the program
screen.
• It a program is already in memory,
push AT and ► to select an unused
program number.
- - SET PROGRAM - -•
VCR PI us 4- PROGRAM
[TIMER PROGRAMl
SELECT:A ▼ KEY
SET : ► KEY
END :PROG KEY
SELECT :* V KEY
SET : ► KEY
END :PROG KEY
• When recording programs via a DSS
receiver, the DSS receiver must be
left on.
• When recording programs via an
antenna or cable, the DSS receiver
must be turned off.
Push AW and ► to select and
set one of the following:
• 1~31 =One time recording
• DAILY =Same time MON-FRI
• WEEKLY =Same time once a week
Example
^ ♦ 8—9.'31“ 1 "" ^.t»——^
7 SELECTA / ▼ Selection Order DAILY
(^WEEKLY.WEEKLY_WEEKLY _J
■ 3 1 — 1 — 2-
Today’s
Date
(SAT)
(MON) (SUN)
Push AW and
to select and set
each of the remaining
items at right.
To Make Corrections
Repeatedly push ► to move the cursor to the right,
or 4 to move to the left to the incorrect entry and
make the correction.
Remaining Items
to be set:
• START time
• STOP time
•CH(annel) number,
or LINE for outside
source recording
• Speed (SP, LP, SLP)
Push PROG to end
the program.
• This screen appears for
confirmation.
To Enter More Programs
Push AT and ► to select and set a blank
program number, and then repeat steps 3 and 4.
P DT START STOP CH SPD
2-
—
.T KEY
▼ KEY
CEY
4 -
CANCEL
SELECT
ENTER
END
ADD/DI
1-8:*
► KEY
PROG
Push PROG to exit this
mode and return to the
normal screen.
Push POWER off
to set the timer.
• When recording programs via
a cable box, make sure the
cable box is left ON and Multi Function Display
tuned to the desired channel.
• A cassette with no record tab is ejected and TIMER indicator flashes when the power is turned off to set the timer.
• If the start times of two programs overlap, the lower numbered program will have priority.
• If the start time for a timer recording comes up during a normal recording or One Touch Recording (page 16),
the timer recording will not be performed.
• If there is a power interruption of more than one minute, the recording will not be performed or continue.