Panasonic Omnivision PV-7451 - Tape Operation

k < 1 —b i v Tape Operation
Your VCR is equipped with several
time saving features as well as
convenient automatic functions making
tape operation easier than ever.
[ Auto Operation Functions
Auto Playback
When a tape is inserted, the power
turns on (Auto). If the record tab* is
removed, playback begins (Auto).
Auto Rewind
When a tape reaches its end during
playback, fast forward or manual
record, the VCR will rewind and go
into Stop mode.
Playback Auto Eject
(Repeat Play is “OFF.”)
When a tape without a record tab* is
played to its end, the VCR will rewind
and then eject the tape.
Memory Rewind Off
When the POWER button is pushed
during rewind, the VCR will turn off
after rewind is complete.
* For record tab information, see page 5.
20
Repeat Play
The VCR will play your recording over and over.
Push MENU to
display the menu.
MENU
SET UP CHANNEL
ID IOMA/LANGUE: ENGL ISH
SELECT :i T KEY
SET : ► KEY
END :MENU KEY
Push AT to select
“SET UP VCR,” and
then push W to display
the “SET UP VCR” screen.
. SET UP VCH .
REPEAT PLAY
BEEPER
ON
ON
Push AT to select
“REPEAT PLAY,” and
then push ► to select
• “ON” or “OFF.”
The VCR plays back the tape to its
end or until a blank portion of over
30 seconds is detected (erased
portions are not considered blank). The tape is then rewound
and played again and again until Repeat Play is turned off.
SELECT
SET
END
A ▼ KEY
► KEY
MENU KEY
Push MENU twice to return
to the normal screen.
One Minute Skip
The VCR rapidly skips over one minute of tape.
Push ZERO/1 MIN
in Play mode.
1 MIN <
* The VCR will go into FF search mode and skip over 60 seconds
of recorded time. Normal playback will then resume.
Zero Search
To quickly return to a specific tape location.
Push DISPLAY to
display the Time
Counter overlay.
STOP 12:00AM CH08
0:00:30
SLP
(STEREO)
(SAP)
MONO <
COUNTER
Push COUNTER
RESET to reset the
reset Time Counter to
' “0:00:00.”
This may be done at as many places
as you wish on the tape.
STOP 12:00AM CH08
0 : 0 0:00
SLP
(STEREO)
(SAP)
MONO <
ZERO/
o
1 MIN
Push ZERO/1 MIN
in Stop mode.
• The VCR will go into FF or REW mode and stop at
the last point the Time Counter was set to 0:00:00.