Panasonic Omnivision PV-7451 - VCR Plus+ Programming

VCR Plus+ Programmin
1^^ Before you begin, make sure... CH)
n Thn r'\r\r^is ic*
□ The clock is set.
□ VCR Plus+ Setup is complete
(see pages 24, 25).
Multi Function Display
Push PROG to
display the “SET
PROGRAM" screen.
/g^\ ▲ ' Push AW to select
i>:“VCR Plus+
; PROGRAM," and then
^ - push ► to display the
“VCR Plus+” screen.
/£\\ Push the NUMBERED keys to
enter the PlusCode number.
* Refer to your local TV listings.
To Make Corrections
Push 4 repeatedly to delete the PlusCode
number. Then, enter the correct number.
ENTER PLUSCODE NUMBER
si/
USING 0-9 KEYS
END :PROG KEY
ENTER PLUSCODE NUMBER
USING 0-9 KEYS
BACKSPACEKEY
ENTER :PROG KEY
SPEED
!
msmJi
□ CD *
PM»C SW [t
_0 0 ©
0 0 ©
© 0
Wm
-^sa
ADD/
DELETE
Push PROG to lock in
your program.
Push the 1, 2 or 3 key to
select the program type.
To change the recording speed:
Push SPEED for SP, LP or SLP.
To cancel program contents:
Push ADD/DLT.
1 ONE TIME
2 DAILY(MON-FRI)
3 WEEKLY
TO SELECT PUSH 1,2 OR 3
DATE START STOP
TO CHANGE RECORD SPEED
PUSH SPEED KEY
CANCEL :ADD/DLT KEY
ACCEPT:PROG KEY
If you use connection type “A” on page 24, the channel shown in this
on-screen display will always be the cable box output channel number.
Use normal Timer Recording steps if:
• the PlusCode for a program is not listed.
• you anticipate the program, such as a sporting
event, to run over the scheduled stop time.
See page 19 to:
• cancel a timer recording in progress.
• replace program contents.
• review or clear program contents once set.
Important notes when using a DSS receiver
•When recording programs via a DSS receiver,
the DSS receiver must be left on.
• When recording programs via an antenna or
cable, the DSS receiver must be turned off.
’ Push PROG
if contents are
i acceptable.
j Push PROG to
complete the
program.
If you’re using a Cable Box, make sure
that it is tuned to the desired channel and
the power is left on for timer recording.
Push POWER off
to set the timer.
P DT START STOP CH SPD
1 DAY 9:OOA 12:OOA 08 SP
3 - ; - — —
4 - ; - — __
CANCEL:ADD/DLT KEY
SELECT 1-8:A T KEY
ENTER > KEY
END :PR0G KEY
TURN VCR OFF
FOR TIMER RECORDING
AND
LEAVE CABLE BOX POWER ON
This display may differ depending
on your cable box hook-up.
- ^ 17 . 14:1 ~
I S
Multi Function Display
mms]
For a list of publications that carry the PlusCode numbers in your area, call 1 - 800 - 258 - 4827.
You can obtain unlisted PlusCode numbers by calling 1 - 900 - 454 - 7587. Call costs approximately $.95 per minute.
VCR PlusCodes can not be used to program the VCR to record DSS channels.
Avoid overtapping program times.
An on-screen display will indicate if an invalid PlusCode number has been entered or when all timer programs are full.