Panasonic Omnivision PV-9401 User Manual

sasic Connection
Congratulations
on your purchase of one of the most sophisticated and
reliable products on the market today. Used propeny,
it will bring you and your family years of enjoyment.
Please fill in the information below. The serial number
is on the tag located on the back of your VCR.
¢ Date of Purchase
* Dealer Purchased From
* Dealer Address
e Dealer Phone No.
* Mode! No.
* Serial No.
Accessories
O Remote Control C] Batteries 2 “aa”
VSQS1597 (PV-9401) d
VSQS1596 (PV-9451)
$ ____)
O RF Coaxial Cable
VJAS0196
| Model PV-9451
/ remote is
© shown here.
To order accessories, cal! toll free
1-800-332-5368.
Loading the Batteries
Bs 1) Open the cover.
3
2)
Insert
the
CH
batteries
as
ay
marked.
EZ)
£7
Y 3) Close the cover.
L] Battery replacement caution
* Do not mix old and new batteries.
* Do not mix alkaline with manganese batteries.
4
ANTEN NA (See page 5)
CABLE TV
OUTDOOR ANTENNA INDOOR ANTENNA
Disconnect antenna
or cable from TV and
VC R connect to VCR.
IN FROM/ ANT ©
OUT TO TV
3 ch 4
channel 3 or 4 (not
an active station).
2
Connect VCR
to TV with RF
Coaxial Cable.
TV
Tune TV to VCR output channel
the same one you set in step 3.
WARNING
When using “Nut type” RF coaxial cables, tighten with
fingers only. Overtightening may damage terminals.
For assistance, call 1-800-211-PANA(7262).
E Set VCR Output to
VHF/UHF

Panasonic Omnivision PV-9401 Specifications

General

Brand	Panasonic
Model	Omnivision PV-9401
Category	VCR
Language	English