Panasonic Omnivision PV-V4540

"Important: If the remote control POWER, ACTION, PROG/V Hå/Y, ER
INPUT, SEARCH or ADD/DLT button does not ware when pressed, press the VCR
button on the remote and try the button again.
P DT START STOP CH SPD
1 8 10:00P12:00P 02 SP
2 =- la o o --
3 en tan o o
4 -= ooo oo
CANCEL :ADD/DLT KEY
SELECT 1-8:4 ¥ KEY
ENTER :» KEY
END :PROG/ACTION KEY
Multi Function Display
End the program.
1) Press PROG/VCR+
of
(or ACTION).
To Enter More Programs
Press AY to select, and P to
display a blank program number,
Then repeat steps 3 and 4.
2) Press PROG/VCR+
(or ACTION) again to
exit.
Set the timer.
Press Power off.
* When recording
programs via a cable
box, make sure the
cable box is left ON
and tuned to the
desired channel.
Review, Replace or Clear Program Contents:
(Recording is not in progress)
a Repeat steps 1~2 on page 12.
P DT STAAT STOP CH SPD
2 8 10:00P12:00P 02 SP
3 10 8:00P 9:00P 10 SP
b
4 SU 9:00P10:00P t1 LP
CANCEL : ADD/OLT KEY
SELECT 1-8:4 ¥ KEY
CATEGORY: MOVIE
NOTES: STAND BY ME
SELECT START DATE
SELECT:A ¥ KEY
SET ¿4 > KEY
or
To Clear program...
P DT START STOP CH SPD
2 8 10:00P 12: 00P 02
3 10 8:00" 9:00P 10
4 SU 9:00P 10:00P Li
SELECT 1-8:4 v KEY
ENTER :» KEY
Select program.
1) Press AY to
select number.
1) Press > to display.
2) Press AV dP to
set new program
contents.
1) Press ADD/DLT.
ADD/DLT
End the program.
1) Press PROG/VCR+ (or ACTION).
* If there are programs, press
POWER off.
To cancel Timer Recording
(Recording is in progress)
Press POWER and then STOP
within 10 seconds to cancel the
Timer recording. (The TIMER
indicator goes out on Multi
Function Display.)
Multi Function Display
SELECT/
ADD/
C DELETE
PAUSE CM SKIP SPEED SEARCH
Ow
md? O]
2 |\|O O:
REC
(0)
13
Suip10229y 13 |