Panasonic Omnivision PV-V4540

ape Operation
Search System
Each time a recording is made, an invisible index mark is placed on the tape. When timer recordings are made,
program index and information are also included. These index marks can be used to access or scan recordings.
Program End Search
It is easy to locate the end of a recorded program allowing you to continue
recording where you left off.
Display SELECT SEARCH
O MODE in Stop or Play mode.
y Press SEARCH.*
SELECT SEARCH MODE Select PROGRAM END
ZERO SEARCH SEARCH. ;
INDEX SEARCH
PROGRAM END SEARCH Ñ 1) Press AY to select.
| | 2) Press P to
SELECT: 4 Y KEY a CS ss start search.
Y E
SET :> KE
END ¡SEARCH KEY
Examples of Program End Search operation.
Fiat
[|
y
Programi
JMEJ[
Program
2
or
Brank
the
current
tape
position
y
.
Press
SEARCH
button
End
Point
FF
the current tape position
Press SEARCH button
y
End
Point
Q
CM
SKIP
SPEED
O
OOOO
FF
the current tape position
Press SEARCH button
eoa 6 12200 e CA
é If can not find over
End Point a few seconds
FF when BLANK zone
searching.
if Program End Point (y) is found.
The search continues slightly beyond the end point, then rewinds and
plays the last few seconds of the program and finally stop.
[x Program TE Program 2 (BLANK)
the
currant
tape
position
|!
¿Notes
]
Press SEARCH button
i SEARCH ¢ If Program End Search is started
FF
PLAY
———»
;
REVERSE
SEARCH
very
close
to
an
index
mark,
one
le senses ti program may be skipped over.
STOP
*
To
cancel
Program
End
Search,
press PLAY or STOP.
22 For assistance, call 1-800-211-PANA(7262).