Panasonic Omnivision PV-V4540

Head Cleaning
Playing older or damaged tapes may eventually
cause video heads to become clogged.
Video Head Clog Sensor
During playback this
screen appears if
clogging is detected. | NEED CLEANING
PLEASE INSERT HEAD
To remove screen, ET EAine GAccrTie
press PLAY on the OR REFER TO MANUAL
remote or VCR.
END:PLAY KEY
» Use “dry” type head cleaning cassette only.
(Part No. NV-TCL30PT is recommended.)
= Cleaning Tape
* Follow cleaning tape instructions carefully.
Excessive use of tape can shorten head life.
* If head clog symptoms persist, contact your
nearest Factory Service Center or authorized
Service Center. (See page 41.)
Cleaning the VCR
Use a soft cloth or dusting attachment of
your vacuum cleaner to dust your VCR.
Remove dust from the ventilation holes on
the back sides and bottom of the cabinet.
Plastic surfaces are easily scratched and
can be marred by alcohol and various
solvents. Avoid excessive use of oil-based
furniture polishes since the materials used
in the cabinet will accumulate more dust.
We recommend using a nonabrasive,
antistatic cleaner and polisher.
Specifications
Power Source: 120 V AC, 60 Hz
Power Consumption: Power On
Approx. 23 watts
Power Off
Approx. 3.3 watts
Video Signal: EIA Standard NTSC color
Video Recording System: 4 rotary heads helical
scanning system
Audio Track: 1 track (Normal)
2 channel (Hi-Fi Audio Sound)
Tuner:
Broadcast Channels: VHF 2~13, UHF 14~69
CABLE Channels: Midband A through ! (14-22)
Superband J through W (23-36)
Hyperband AA-EEE (37-64)
Lowband A-5-A-1 (95-99)
Special CABLE channel 5 A (01)
Ultraband 65-94, 100-125
Operating Temperature:5 °C~40 °C (41 °F~104 °F)
Operating Humidity: 10 %-75 %
Weight: 3.0 kg (6.6 Ibs.)
Dimensions: 380 (W) x 93 (H) x 250 (D) mm
14-15/16” (W) x 3-11/16” (H) x
9-3/4” (D)
Note: Designs and specifications are subject to change
without notice.
Features for a Quality Picture
Digital Auto Picture
Automatically controls the video output signal for
less noise depending on the tape condition.
Digital Auto Tracking
Continuously analyzes the signal and adjusts for
optimum picture quality.
Manual Tracking Control (to reduce picture
noise)
Use during Playback and Slow Motion mode to reduce
picture noise. Press CH (TRACKING) A / Y buttons on
the remote control or on the VCR until the picture clears
up. To return to Auto Tracking, press POWER off, then
on again a few seconds later.
V-Lock Controt (to reduce picture jitter
In Still mode, CH (TRACKING) A / Y operate as
a V-Lock control.
37
<
O
D
go
©
D
V
wn
©
=
1)
53
pu
o
=
3
=
o
5