Panasonic Omnivision PV-V4540

Multi-Brand Control Feature
The Remote Control may be set up to control some TV or Cable/DSS Box functions.
Multi-Brand Control Setup
1 Find your TV, Cable or DSS Receiver Brand
Code Number on following page.
GOED EJECT UGHT 3 POWER
Setup for TV Setup remote.
Hold down TV and enter code 2 TV or
with NUMBERED keys. DSS/CABLE
Hold down DSS/CABLE and
enter code with NUMBERED keys. m NUMBERED
* For code 100 or greater, press the É keys
100 key first, then remaining digit.
E.g. for 102, press 100, then press 0,
and then press 2.
Confirm
code
entry.
a
i
Press
POWER
to
turn
“uo
selected unit on or off. O cio i =
Oo O
X
e See table below for list of
controllable functions in each mode.
f Notes) * Please repeat Multi-Brand Contro! setup after replacing remote
control batteries.
¢ The remote control will not operate all TVs, Cable Boxes, and
DSS receivers made by manufacturers listed. If you get no
results, your particular brand cannot be controlled.
Using the Multi-Brand Control
After remote control is setup, you can select VCR, TV, or DSS/CABLE for the desired function.
Press VCR or TV or DSS/CABLE on the remote control.
This table shows which buttons are available for each mode.
Available
Buttons VCR TV
All Functions VOL UP/DOWN
VCR/TV, PLAY, STOP
TV
EJECT,
SAP/Hi-Fi,
POWER,
INPUT,
DISPLAY
FF,
REW,
NUMBERED
keys,
PAUSE/SLOW,
REC,
NTER,
CH
UP/
D
SPEED,
COUNTER
RESET
a
Heelies
Own,
TAPE
POSITION,
CM
SKIP
CABLE/ DSS VOL UP/ DOWN
( Note ) In TV or DSS/ CABLE mode, it may be necessary to press ENTER after pressing NUMBERED keys for channel selection.
CABLE/ DSS
VCR/TV, PLAY, STOP
EJECT, SAP/Hi-Fi,
DISPLAY,FF, REW,
PAUSE/SLOW, REC,
SPEED, COUNTER RESET
TAPE POSITION, CM SKIP
POWER, ENTER,
NUMBERED keys
(except 100key),
CH UP/ DOWN
For assistance, call 1-800-211-PANA(7262).