Panasonic Omnivision PV-V4540

*Important:
If
the
remote
control
POWER,
ACTION,
PROG/VCR+,
CHA/V,
ys,
INPUT,
SEARCH
or
ADD/DLT
button
does
not
work
when
pressed,
press
the
VCR
button
on
the
remote
and
try
the
button
again.
Repeat Play
Set to see a recording over and over.
Display MENU.
HA
Press ACTION.*
MENU
SET U
SET UP FEATUAE
SET CLOCK
SET UP CHANNEL
IDI OMA/ LANGUE: ENGL | SH
VCR’ S OUTPUT CH:3
SELECT:4 Y KEY
SET :> KEY
Display SET UP VCR.
2) Press » to display.
SET UP VCR
TIME STAMP
REMOTE WARNING
1) Press AY to
select “REPEAT
PLAY.”
2) Press P to set.
AUTO SHUT-OFF
SELECT:4 ¥ KEY
> KEY
¿ACTION KEY
SET
END
AN
Zero Search
To quickly return to specific tape counter location.
Display Counter
a DISPLAY i A
CO)
Press DISPLAY during playback.
12:00AM Reset to “0:00:00.”
PLAY
b
0:00:00
Press
COUNTER
“O a RESET at the desired
position.
C Continue to record, playback etc.
d
SEARCH
,
Display
SELECT
SEARCH
O-
MODE in Stop mode.
SELECT SEARCH MODE
Press SEARCH.*
» Playback repeats when tape end is
seconds is detected.
Return to normal screen.
Press ACTION twice.
Start ZERO SEARCH.
I NDEX SEARCH
PROGRAM END SEARCH
PROGRAM INDEX SEARCH
2) Press > to start.
SELECT:4 Y KEY
SET
END
:> KEY
“SEARCH KEY e Unit will go into FF or REW mode
and stop at the last point the Counter
was set to 0:00:00.
1) Press AY to select.
reached or unrecorded portion over 30
1) Press AY to select.
LIGHT
EJECT
uonelado ade]
Commercial Skip
VCR fast forwards (skips) over 1-3
minutes of recorded tape.
A CM SKIP Press CM SKIP in
Play mode.
* The skip time can be changed by pressing
CM SKIP button repeatedly as shown
by the figure below.
PLAY
kd
1st Press — 1 min Skip
t
2nd Press — 2 min Skip
7
3rd Press — 3 min Skip
25