Panasonic Omnivision PV-V4540

*Important: If the remote control POWER, ACTION,
INPUT, SEARCH or ADD/DLT button does not work when pressed, press the VCR
button on the remote and try the button again.
Process of Recording
Cable Box Setup
MENU
SET UP VCR
SET UP FEATURE
SET CLOCK
SET UP CHANNEL
IDIOMA? LANGUE: ENGL I SH
VCR: S OUTPUT CH:3
SELECT :à ¥ KEY
SET ¿> KEY
END ¡ACTION KEY
SET UP AINEL
CHANNEL CAPTION
WEAK SIGNAL DISPLAY : OFF
CABLE/DSS BOX SET UP
VCR Plus+ CH SET UP
SELECT:4 Y KEY
SET :b KEY
END ¡ACTION KEY
SELECT HOOKUP
VCRPCABLE/DSS BOXPTV
VCRPTV
SELECT:4 Y KEY
SET z> KEY
END :ACTION KEY
SELECT HOOKUP
CABLE/DSS BOXPVCRP TV
CABLE/DSS BOX OUTPUT CH
SELECT:á4 Y KEY
SET :4 > KEY
END ¿ACTION KEY
Connection) => [Sap] => Programming
Display MENU.
Press ACTION.*
Select SET UP CHANNEL.
1) Press AY to
select.
2) Press > to
display.
Select CABLE/DSS BOX
SET UP.
1) Press AY to
select.
2) Press > to
display.
Select your hookup
method.
1) Press AY to
select.
* If CABLE/DSSBOX PVCR PTV,
go to step 5.
lf other, press ACTION three
times and go to page 16.
Select cable box or DSS
receiver output channel.
1) Press AY to
select.
"*| 2) Press » to
enter.
* lí necessary, refer to your Cable
Box/DSS manual.
¢ If you are using Audio/Video jack
connections, select and set
“VIDEO OUT” as output channel.
End setup.
Press ACTION twice.
2) Press ® to set.
SELECT/
1 ACTION
6
PAUSE CM SKIP SPEED SEARCH
SLOW
e 2
YOL CH | REC
Sl O10
VCR Plus+® PlusCode and ALL
SET are registered trademarks
of Gemstar Development
Corporation. The VCR Plus+
system is manufactured under
license from Gemstar
Development Corporation
A ESR
15
=
3
D
=
J
D
Q
e]
-—
o
5
Q
Cc
2,
5
Ta)
<
(P)
J)
y
=
G
+
07)
<
En
D
3