Panasonic Omnivision PV-V4540

Timer Recording Using VCR Plus+ System (continued)
Auto VCR Plus+ System Process of Recording
Channel Setup (Part 1) Connection => | Setup | =>
v cual for an to nee oe Plus+ code, some set up is required. Guide
us+) channel number is assigned to each local broadcast and i
cable station. Because this number sometimes differs from channel TV Programming
receives station on, it is necessary to program the VCR with loca! channel
information. To receive VCR Plus+ channels automatically, perform the Important Note
steps below. ; e The “One Time VCR Setup” section on
Or, see “Manual VCR Plus+ System Channel Setup” section on page 18. pages 6 and 7 must be completed before
the “Auto VCR Plus+ System Channel
Display MENU. Setup” section can be done.
Press ACTION.” If any part of the setup is not completed,
a warning screen appears.
* If your VCR connection type changes
from type A to B, repeat steps 1~4 of
MENU Display Ly a Display SET UP CHANN UP CHANNEL. page 15 and select VCR»CABLE/DSS»
SET UP VCR TV before proceeding with these steps. :
a E : 1) Press AY to + Complete this page only if type B
select. ioni
50 connection is used.
10 (OMA / LANGUE: ENGI. | SH -D Erel 9) Drogg lo +
€ VCR' S OUTPUT CH:3 $ ETRA
SELECT:A Y KEY | ee display.
SET :b KEY
Display VCR Plus+ CH
SET UP.
1) Press AV to SELECT/
select. SET
eae
aa
©
|
2)
Press
>
to
are
SET :b KEY display. y :STOP
END ¡ACTION KEY 4: REW
»:FF
VCR Plus+ CH SET UP Select AUTO SET.
1) Press AV to 1 ACTION
AUTO SET
MANUAL SET
select.
j “| 2) Press P to set.
SELECT:A ¥ KEY
SET :» KEY
VCR Plus+ CH SET UP Enter Zip Code.
1) Press AV 4 >
to select and
enter each
number.
2) Press » or
ACTION to set.
PLEASE ENTER ZIP CODE
ZIP CODE: M----
SELECT:4 Y KEY
:» KEY
: ACTION KEY
PLEASE SELECT How OFTEN | Select Update Frequency.
TO UPDATE
1) Press AV to
select.
EVERY NIGHT E e
EVERY MONDAY NIGHT ED 2) Press P to set.
* Make each entry within 5 minutes or VCR will
VCA Plus+ CH SET UP End setup. leave this mode.
* Once local channels have been
PLEASE LEAVE VCR OFF Press ACTION. programmed, they will stay in memory, even
(OVERNIGHT) in the case of a power failure.
O e if the start time for a timer recording comes
up during Auto VCR Plus+ System Setup, the
e Make sure to leave VCR off timer recording will have priority.
ENO :ACTION KEY (overnight.) If controllable, leave
your cable box on.
For assistance, call 1-800-211-PANA(7262).