Panasonic Omnivision PV-V4540

“Important:
IA cheek list before you begin.
O The clock is set.
C] VCR Plus+ System Setup is complete (
the remote control POWER, ACTION, P
INPUT, SEARCH or ADD/DLT button does not work when pressed, press the VCR
button on the remote and try the button again.
VCR Plus+ System Programming
E
5
6f
vis
1)
Press
PES
Numbered
USING
0-9
KEYS
keys.
2)
Press
PROG/
To
make
corrections,
VCR+
to
lock
press «€ repeatedly to delete the
PlusCode programming number.
Display SET PROGRAM.
Press PROG/VCR+.*
Display VCR Plus+
SET PROGRAM
screen.
VCR Plus+ PROGRAMMING 1) Press AV
TIMER PROGRAMMI NG to select.
2) Press >
SELECT:A ¥ KEY l
SET :» KEY to display.
END :PROG KEY
Enter PlusCode
programming number.
VCR Plus+ SYSTEM
ENTER PLUSCODE NUMBER
in the program.
VCR Plus+ SYSTEM
DAILY (MON-FRI)
WEEKLY
1) Press av to
select program
type.
2) Press > set.
SELECT:4 ¥ KEY
SET :» KEY
END :PROG KEY
Select Category.**
1) Press av to
change.
2) Press » set.
DATE START STOP CH
8 SAT 10:00P 12:00P 02
TODAY AIZ
CATEGORY :N/A
etre
SELECT: Y KEY
SET :4 > KEY
END :PROG/ACTION KEY
Change record speed.
Repeat 1) and 2).
Make notes. ----- > Do step 4 on page 12.
¢ If not wanted, go to step 6.
End programming.
1) Press PROG/VCR+
(or ACTION).
To cancel
press ADD/DLT.
2) Press PROG/VCR+
(or ACTION) again to
exit.
P DT START STOP CH SPD
1 DAY 9:00A12:00A 08 SP
8 10: 00P 12:00P a SP
5 e a z2
4 -=-= o ==-
CANCEL : ADD/DLT KEY
SELECT 1-8:4 ¥ KEY
ENTER :» KEY
END ¡PROG/ACTION KEY
Set timer.
Press Power off.
Multi Function Display
Process of Recording
see
pages
14-18).
Connection
[¡Connection|
=>]
Setup
|
|
Setup
|
=>
Pega
/ POWER
2 SELECT/
~ SET
Y ¿STOP
d REW
> :FF
1 PROG)
A VCR+
3
6
6 ACTION
NUMBERED
keys
ADD/
DELETE
** Category Items
N/A(not applicable}, SPORTS,
MOVIE, COMEDY, MUSIC, DRAMA
Usenormal Timer Recording steps if:
* the PlusCode programming number for
a program is not listed.
* you anticipate the program, such as a
sporting
Sent to run over the scheduled stop
ime.
See page 13 to:
* cancel a timer recording in progress.
* replace program contents.
* review or clear program contents once
set.
Important notes for DSS/Cable Box
users
+ When recording via DSS, the receiver,
must be left on.
* When recording via cable or antenna,
DSS receiver must be off.
* Avoid overlapping program times.
* VCR PlusCode programming numbers
can not be used to program the VCR to
record DSS channels.
+ You can obtain unlisted PlusCode
numbers by calling 1 - 900 - 454 - 7587.
Call costs approximately $.95 per minute.
19
113ISÁS +SNId HDA Bus) Bulpsosay sou