Panasonic Omnivision PV-V4540

en Use Guide
Make all connections (page 4).
Connect VCR and TV with AV Cable (not supplied) or RF Coaxial Cable (supplied) as shown below.
To use your TV as a VCR monitor, set the VIDEO/TV selector on the TV (Monitor/Receiver) to “VIDEO.”
Use the L Audio OUT jack for proper sound reproduction when connecting to a monaural TV.
ANTENNA (See pages 4, 5)
AUDIO
IN OUT
R
O AUDIO
LO
IN FROM ANT. a) AV CABLE -
{not supplied)
MONO :
L VHF/UHF ;
ow mn O VIDEO
@—_______© ] VHF/
IN OUT ) RK
. b) RF COAXIAL
VCR CABLE TV
Notes) 1) While connection b) (above) is sufficient, connection a) offers better sound and picture
(especially with model PV-V4540, you can enjoy Hi-Fi STEREO sound).
2) For both connections a) and hi proceed as follows:
* To use VCR : VCR Power on, set TV to VIDEO.
e To watch TV : VCR Power off, select channel on.
3) When using connection b) (see page 4), tune to VCR's output channel.
4) Set VCR Output to channel 3 or 4 (not an active station). (See page 6.)
Playback
a
Tape
Record
on
a
Tape
2
Play
your
Tape.
2
Do
“One Time
VCR
Setup”
on
page
6.
In order for the VCR to properly interface with your
Insert a tape equipment, some setup is necessary.
(INM
= 3 Record on a Tape.
e —, Insert a tape
KX“... 0 _\\ with Record Tab
a y S
Press PLAY
(Starts playback)
» Or, if tape has no record
tab, auto playback begins. Press CH Up/Down.
(Select Channel}
O = C) Sill
4TRACKING>
Q
Press SPEED.
(Change speed)
Press REC.
(Starts Recording)
Panasonic Consumer Electronics Panasonic Sales Company, Printed in Japan
Company, Division of Matsushita Division of Mannan ee of LSQT0192A
Electric Corporation of America Puerto Rico, Inc. (“PSC”) 51299-0
One Panasonic Way Secaucus, Ave. 65 de Infantería. Km. 9.5
New Jersey 07094 San Gabriel Industrial Park, Carolina,
Puerto
Rico
00985
P]