Panasonic Omnivision PV-V4620 User Manual

Timer Recording Using VCR Plus+ System (continued)
Auto VCR Plus+ System
Channel Setup (Part 1)
In order for VCR to read VCR Plus+ code, some set up is required. Guide
(VCR Plus+) channel number is assigned to each toca! broadcast and cable
station. Because this number sometimes differs from channel TV receives
station on, it is necessary to program the VCR with local channel information.
To receive VCR Plus+ channels automatically, perform the steps below.
Or, see “Manual VCR Plus+ System Channel Setup” section on page 18.
AA
Process of Recording
Pri ee
Programming
Important Note
e The “One Time VCR Setup” section on
pages 6 and 7 must be completed
before the “Auto VCR Plus+ System
Channel Setup” section can be done.
If any part of the setup is not
completed, a warning screen appears.
+ If your VCR connection type changes
from type A to B, repeat steps 1~4 of
page 15 and select VCR»CABLE/DSS»>
TV before proceeding with these steps.
+ Complete this page only if type B
connection is used.
Display MENU.
Press ACTION.*
Display SET UP CHANNEL.
o | 1) Press AY to
SZ: select.
"So Press P to
display.
MENU
SET UP VCR
SET UP FEATURE
SET CLOCK
IDIOMA? | LANGUE: ENGL I SH
VOR 3 OUTPUT 0n:3
SELECT:à ¥ KEY
SET :> KEY 0
Display VCR Plus+ CH
SET UP CHANNEL
ANTENNA : CABLE
AUTO SET 4 SET UP.
CHANNEL CAPTION
WEAK SIGNAL DISPLAY : OFF 1) Pi AY to SELECT/
CABLE/DSS BOX SET UP selec SET
e C3 e| 2) Press P to t “A PLAY
SET :b KEY - display. v :STOP
END :ACTION KEY <-REW
> :FF
` VCR Plus+ CH SET UP Select AUTO SET.
1)
Press
AY
to
1
ACTION
AUTO SET
MANUAL SET select,
2) Press > to set.
7
SELECT:A ¥ KEY
SET.. .: KEY.
COUNTER RESET DISPLAY TAPE POSITION
Enter Zip Code. 220 Re
1) Press AV «4» D
to select and
enter each
number.
2) Press P or
ACTION to set.
VCR Plus+ CH SET UP
PLEASE ENTER ZIP CODE
ZIP CODE: G----
SELECT:á ¥ KEY
SET i» KEY
END ¡ACTION KEY
Select Update Frequency.
1) Press AY to
select.
| 2) Press P to set.
PLEASE SELECT HOW OFTEN
TO UPDATE
[RIGHT NOW]
EVERY NIGHT
EVERY MONDAY NIGHT
¢ Make each entry within 5 minutes or VCR will
leave this mode.
* Once local channels have been
VCR Plus+ CH SET UP
End setup.
PLEASE LEAVE VCR OFF
(OVERNIGHT)
END ¡ACTION KEY
a Press ACTION.
+ Make sure to leave VCR off
(overnight.).
programmed, they will stay in memory, even
in the case of a power failure,
* “SET” will flash on Multi Function Display
during Auto VCR Plus+ System Setup.
* If the start time for a timer recording comes
up during Auto VCR Plus+ System Setup, the
timer recording will have priority.
For assistance, call 1-800-211-PANA(7262).

Panasonic Omnivision PV-V4620 Specifications

General

Brand	Panasonic
Model	Omnivision PV-V4620
Category	VCR
Language	English