Panasonic Omnivision PV-V4620 User Manual

Tape Operation
Search System
Each time a recording is made, an invisible index mark is placed on the tape. When timer recordings are made,
program index and information are also included. These index marks can be used to access or scan recordings.
Program End Search
it is easy to locate the end of a recorded program allowing you to continue
recording where you left off.
sean Display SELECT SEARCH
O- MODE in Stop or Play mode.
M/A SKIP Press SEARCH/ M/A SKIP.*
SELECT SEARCH MODE Select PROGRAM END
ZERO SEARCH SEARCH.
INDEX SEARCH
1) Press AY to select.
2) Press P to
siari search.
PROGRAM INDEX SEARCH
Examples ot Program End Search operation.
[POCO E IEA
the current tape position y E
- Press SEARCH button End Point
2 SELECT/
SET
A ¡PLAY
Y ¿STOP
> :FF
Fig. 1
FF
Fig.2 [EJ[ Program 1 [pecan [a] Progam 2 || BLANK
the current tape position y ,
Press SEARCH button End Point
FF
the current tape position
Press SEARCH button
Fig.3 [Eom Pan]
End Point $
{ SEARCH
M/A SKIP
lf search exceeds
a few seconds in
BLANK area.
If Program End Point (=p) is found.
The search continues slightly beyond the end point, then search and reverse search
and plays the last few seconds of the program and finally stops.
[e Progam J]. Programa (BLANK)
the current tape position :
Press SEARCH button ; SEARCH y
—
td
>
*
If
Program
End
Search
is
started
FF
PLAY
——
;
REVERSE
SEARCH
very
close
to
an
index
mark,
one
Lape a ae naan denon...”
STOP program may be skipped over.
* To cancel Program End Search,
press PLAY or STOP.
26
For
assistance,
call
1-800-211-PANA(7262).

Panasonic Omnivision PV-V4620 Specifications

General

Brand	Panasonic
Model	Omnivision PV-V4620
Category	VCR
Language	English