Care and replacement
88 -
ENGLISH
Maintenance
Press the <MENU> button to display the 20)
menu screen and select [OPTION] with
the ▲▼ buttons.
Press the <ENTER> button and select 21)
[LAMP RUNTIME] with the ▲▼ buttons.
Hold the <ENTER> button down for 3 22)
seconds.
The conrmation message is displayed.
z
LAMP RUNTIME
LAMP RUNTIME RESET.
CANCELOK
Select [OK] with the ◄ ► buttons and 23)
then press the <ENTER> button.
LAMP RUNTIME is reset to “0”, and the projector
z
powers off. After a short while, the projector enters
standby mode.
Attaching the top cover
■
Hold the top cover as shown in the
diagram below, align the hinge with the
support, and while pushing the arm in the
direction of the arrow (towards the inner
side of the projector), push it into the
groove.
Arm
Groove
Hinge
Support
To Next Page
Loading...
