Panasonic PT-CW330E

Powering ON/OFF
30
- ENGLISH
Basic Operation
Powering On the Projector
Connect the power plug to the power outlet.1 )
Enter Standby status when the <ON(G)/STANDBY(R)> indicator is lighting / ashing in red.
z
Press the <2 ) > button on the control panel or the remote control.
When the <ON(G)/STANDBY(R)> indicator lights up in green, the lamp is on.
z
Startup screen is displayed for about 10 seconds, then the image will be projected.
z
OR
Powering Off the Projector
Press the <1 ) > button on the control panel or the remote control.
The following message appears.
z
Message will disappear after about 30 seconds when there is no operation.
z
Press the <2 ) > button again.
The projection stops and the <ON(G)/STANDBY(R)> indicator on the projector ashes up in red. (Fan is
z
still spinning.)
Wait until the <ON(G)/STANDBY(R)> indicator lights / ashes up in red (The fan stops 3 )
spinning).
The projector enters standby mode when the <ON(G)/STANDBY(R)> indicator lights / ashes up in red.
z
Note
Do not turn on the power and project images immediately after turning the projector off. Turning on the power while the
z
lamp is still hot may shorten the lamp life.