Panasonic PT-CW330E

Maintenance/replacement
56
- ENGLISH
Maintenance
Clean the air lters.4 )
Vacuum dirt and dust from the air lters.
z
Install the air lters. 5 )
To install the air lters, reverse the previous steps until you hear a "click" sound.
z
Reset the [Filter Reminder].6 )
Turn on the power and perform [Cleaning up Reminder] in the [Options] menu.
z
(
Æ
page 44)
Attention
Turn off the power before you clean the air lters.
z
Be sure to attach the air lters properly. If you use the projector without attaching the air lters, the projector may be
z
damaged due to the dirt or dust.
Note
If the air lter has been damaged or dust / dirt can not be removed, please replace it with a new lter.
z
The <TEMP> indicator lights up and the warning temperature message displays because of clogging within 500 hours,
z
depending on the using environment. In that case, clean the air lter at short intervals.