(7) Unscrew the 2 screws and remove the intake fan unit L.
(8) Unscrew the 1 screw and release the lamp unit terminal.
(9) Unscrew the 3 screws and release the ballast block.
(10) Unscrew the 2 screws and remove the ballast fan.
(11) Disconnect the connectors to the ballast-1 and ballast-2
modules.
(12) While sliding the ballast units 1 and 2 mutually, disconnect their
hooks and separate the units.
Note:
·
Work carefully not to deform the ballast unit case (A,
B).
30
PT-D5600U / PT-D5600E / PT-D5600UL / PT-D5600EL / PT-DW5000U / PT-DW5000E / PT-DW5000UL / PT-DW5000EL
To Next Page
Loading...
