Panasonic PT-D7700U

105
Interface ports
RGB2 input terminal
Video input/output terminal
S-video input terminal
Serial input/output terminal
Remote1 input/output terminal
Remote2 terminal
1 set of high-density, D-sub 15p (female)
[For YPBPR input]
Y: 1.0 V [p-p] synchronization signal included, PBPR: 0.7 V[p-p] 75 Ω
[For RGB input]
0.7 V[p-p] 75 Ω For G-SYNC: 1.0 V[p-p] 75 Ω
HD/SYNC: TTL, high-impedance, positive/negative polarity automatically adjusted
VD: TTL, high-impedance, positive/negative polarity automatically adjusted
• HD/SYNC, and VD terminals are not compliant with 3-value direct
SYNC.
1 set BNC
1.0 V[p-p] 75 Ω (Active through for Video output)
1 set Mini DIN 4p
Y 1.0 V[p-p] C 0.286 V[p-p] 75 Ω Compliant with S1 signals
D-sub 9-pin (female), RS-232C compliant
Used for personal computer control
1 set each for M3 pin jack
Wired remote control, used for link control
D-sub 9p (female)
Used for external control
Length of power supply cord 3.0 m (9.1')
Cabinet Molded resin
Outside dimensions Width: 530 mm (20.8"), Height : 200 mm (7.9"), Depth: 569 mm (22.4")
Mass
Working environment condition
2
.Ambient temperature: 0 °C to 40 °C (0 °C to 35 °C when setting for
lamp power is HIGH and lamp select is DUAL)
Ambient humidity: 10% to 80% (no condensation)
Remote control
Power source
Operation range
Mass
Outside dimensions
Option
Hanging attachment (For high ceiling) : ET-PKD75
Hanging attachment (For low ceiling) : ET-PKD75S
Dual attachment : ET-DFD75
Carrying handle : ET-HAD75
Projection lens : ET-D75LE1, ET-D75LE2, ET-D75LE3, ET-D75LE4,
ET-D75LE5, ET-D75LE8
DVI-D input module : ET-MD77DV
Network module : ET-MD77NT
SD-SDI input module : ET-MD77SD1
HD/SD-SDI input module : ET-MD77SD3
Replacement Lamp Unit : ET-LAD7700 (single bulb), ET-LAD7700W (double bulbs)
Long Life Lamp Unit : ET-LAD7700L (single bulb), ET-LAD7700LW (double bulbs)
Wireless mouse receiver : ET-RMRC2
2.If the projector is used at high altitude (1 400 to 2 700 m), the value for allowable ambient temperature should
be lowered by 5 °C.
22 k (48 lb) (without lens)
3 V DC (two AA dry cells)
approx. 7 m/23' (in front of beam receiver)
110 (0.24 lb) (including dry cells)
Width: 50 mm (1.9"), Thickness: 31 mm (1.2"), Depth: 181 mm (7.1")