95
Adjust clock page
Click [Network set up], then [Adjust clock] to display the Adjust clock page.
Time zone selection
Button to update time zone
setting
Button to update time and
date settings
New date field
New time field
Network config page
Set this to ON to enable the
DHCP client function.
Enter the IP address if DHCP
server is not used.
Enter the net mask if DHCP
server is not used.
Enter the port number here.
Number 80 is normally used.
Enter the gateway address if
DHCP server is not used.
Enter the name of the projector here. Enter the host name
here if it is required when the DHCP server is going to be
used, for instance.
• If the time becomes incorrect immediately after setting the correct time, then the battery needs to be
changed. Contact the dealer where you bought the projector to have the battery changed.
Note
To Next Page
Loading...
