Connecting with Wireless LAN
You can congure settings when the wireless module (ET-WM200E/ET-WM200U) is mounted.
Projector settings
Turn on the projector and press the <NETWORK> button on the remote control.
1
Press the menu button to open the [NETWORK] menu, and then select from among
2
[USER1] through [USER3] for [WIRELESS LAN] and press <ENTER>.
In the conguration of wireless LAN, set [DHCP
3
_
], [IP ADDRESS
_
],
[SUBNET MASK
_
], [DEFAULT GATEWAY
_
], [SSID
_
], [MODE], [AUTHENTICATION],
[ENCRYPTION], and [CHANNEL]. For details, see “USER settings” of
“WIRELESS LAN” (See page 12).
“Glossary” ( _ See page 40 – 41)
Wireless LAN and wired LAN cannot be used in the same segment. ・
When multiple devices are connected, a unique IP address must be allocated to each device. ・
SSID has to be entered in alphanumeric letters. ・
You cannot set “any” or “ANY” for SSID. ・
The following settings are set before the projector leaves the factory. ・
DHCP OFF
IP ADDRESS 19 2.16 8.11.10 0
SUBNET MASK 255.255.255.0
DEFAULT GATEWAY 19 2.16 8.11.1
SSID Panasonic Projector
MODE AD HOC
AUTHENTICATION OPEN
ENCRYPTION NONE
CHANNEL 11
Connecting with Wired LAN
Computer operation
Connection can be made with wired LAN. However, conrm to your system administrator on network settings
before changing any settings.
Turn on the computer.
1
Make the network setting according to your system administrator.
2
If the projector settings are the default settings (See page 11), the computer can be used with the following
network settings.
IP ADDRESS 19 2.16 8.10.101
SUBNET MASK 255.255.255.0
DEFAULT GATEWAY 19 2.16 8.10.1
To Next Page
Loading...
