Panasonic PT-DW530U

18
- ENGLISH
Preparation
About Your Projector
Attention
Do not drop the remote control.
z
Avoid contact with liquids or moisture.
z
Do not attempt to modify or disassemble the remote control.
z
Do not let strong light shine onto the signal receptor. The remote control may malfunction under strong light such as
z
uorescent.
Note
The remote control can be used within a distance of about 30 m if pointed directly at the remote control receiver. The
z
remote control can control at angles of up to ± 15 °C vertically and ± 30 °C horizontally, but the effective control range may
be reduced.
If there are any obstacles between the remote control and the remote control signal receptor, the remote control may not
z
operate correctly.
The signal will be reected off the screen. The operating range may differ due to the screen material.
When the projector receives a signal from the remote control, the Power indicator will ash.
z
Remote control
J
Top view
J
Front view
Installing/removing batteries
Press the tab and lift up the
cover.
Insert the batteries according to
the polarity diagram indicated
inside. (insert the
side rst).
Remove the batteries in the
reverse order to setting.
Remote control
signal emitters
Remote control indicator
Flashes by pressing any buttons
Switch between stand-by mode and projection mode.
These buttons select the RGB1, RGB2, DVI-D, VIDEO, S-VIDEO and HDMI terminals.
(
Æ
page 36)
Displays and clears the main menu, and returns to the previous menu when the menu
is displayed.(
Æ
page 39)
Capture the projected image as a frozen picture. (
Æ
page 36)
Restores the default factory setting. (
Æ
page 39)
Assign the frequently use functions from options for shortcut. (
Æ
page 37)
Species the ID of the remote control. (
Æ
page 21)
Makes the remote control available to control any ID projectors. (
Æ
page 21)
Pressing this button while projecting an image automatically corrects the picture
positioning on the screen. While the auto setup feature is active, a message
“PROGRESS” appears on the screen. (
Æ
page 37)
Navigate through the menu items with ▲▼◄►, and activate them with the <ENTER>
button. (
Æ
page 39)
Turn off the projection temporarily. (
Æ
page 36)
Opens [ECO MANAGEMENT] menu. (
Æ
page 37)
Control to adjust the volume of the speaker. (
Æ
page 38)
You can attach
a favourite
strap onto the
remote control.