PROJECTOR SETUP menu
ENGLISH -
63
Settings
HIGH ALTITUDE MODE
If you use the projector at high elevation (1 400 m to
2 700 m), the [HIGH ALTITUDE MODE] setting needs
to be [ON] to set the fan speed high.
Press ▲▼ to select [HIGH ALTITUDE 1 )
MODE].
Press ◄► to switch [HIGH ALTITUDE 2 )
MODE] and press <ENTER> to select.
The setting will change as follows each time
z
◄► is pressed.
OFF ON
OFF
Select this when using in normal
environment (less than 1 400 m
above sea level)
ON
Select this when using at high
altitude (above 1 400 m and less
than 2 700 m above sea level)
When the conrmation message is 3 )
displayed, select [OK] or [CANCEL].
Note
The loudness of fan noise depends on the [HIGH
z
ALTITUDE MODE] setting.
The separately-sold Smoke Cut Filter cannot be used
z
when the [HIGH ALTITUDE MODE] is [ON].
LAMP POWER
Can switch the electric power of projector lamp. Set
the lamp power to meet the environment and purpose
of projection.
Press ▲▼ to select [LAMP POWER].1 )
Press ◄► to switch [LAMP POWER].2 )
The setting will change as follows each time the
z
button is pressed.
NORMAL ECO
NORMAL Sets the normal lamp intensity.
ECO Sets the reduced lamp intensity.
Note
The [ECO] mode can reduce the power
z
consumption, reduce the operation noise, and
increase the service life of projector lamp.
The [LAMP POWER] may not drop automatically if:
z
You have set the [LAMP POWER] to [NORMAL].
•
Automatic power drop may fail immediately after
•
the lamp is turned on or the [LAMP POWER] is
set.
ECO MANAGEMENT
Can optimize lamp power and reduce the power
consumption according to the application.
Press ▲▼ to select [ECO 1 )
MANAGEMENT].
Press <ENTER> button.2 )
The [ECO MANAGEMENT] screen is displayed.
z
Press ▲▼ to select ECO 3 )
MANAGEMENT.
Press ◄► to switch the setting.4 )
AUTO POWER SAVE
J
[AMBIENT LIGHT DETECTION],
[SIGNAL DETECTION], and [AV MUTE DETECTION]
functions can be used.
Select [AUTO POWER SAVE] in Step 3.1.
Press ◄► to switch [AUTO POWER 2.
SAVE] setting.
The setting will change as follows each time the
z
button is pressed.
ON OFF
Press ▲▼ to select AUTO POWER 3.
SAVE conditions.
AMBIENT LIGHT
DETECTION
Adjusts the lamp power according
to the ambient brightness.
SIGNAL
DETECTION
Drops the lamp power when no
signal is input.
AV MUTE
DETECTION
Drops the lamp power in the AV
Mute mode.
Press ◄►to enable or disable the 4.
selected condition.
The setting will change as follows each time the
z
button is pressed
ON OFF
To Next Page
Loading...
