Chapter 5
Operation of Function — Web control function
116 - ENGLISH
1
1 Self-diagnosis result display
Displays the item check results.
[OK]: Indicates that operation is normal.
[FAILED]: Indicates that there is a problem.
[WARNING]: Indicates that there is a warning.
r [FAILED] items displayed when a problem occurs
Item Description
[FAN] Trouble has occurred in the fan or its drive circuit. Consult your dealer.
[FAN(R_B)] Trouble has occurred in the R/B panel cooling fan.
[FAN(G)] Trouble has occurred in the G panel cooling fan.
[FAN(PBS)] Trouble has occurred in the PBS cooling fan.
[FAN(LAMP)] Trouble has occurred in the lamp cooling fan.
[FAN(REAR)] Trouble has occurred in the rear fan.
[FAN(POWER)] Trouble has occurred in the power cooling fan.
[FAN(EXHAUST)] Trouble has occurred in the exhaust fan.
[INTAKE AIR TEMPERATURE]
The air intake temperature is too high. The projector may be used in an operating
environment where the temperature is high, such as near a heating appliance.
[EXHAUST AIR TEMPERATURE] The exhaust air temperature is high. The air exhaust port may be blocked.
[LAMP REMAIN TIME]
The lamp runtime has exceeded the prescribed cumulative time, and it is now time to replace
the lamp.
[LAMP STATUS]
The lamp has failed to light.
Wait a short while for the lamp to cool off, and then turn on the power.
[APERTURE (CONTRAST-SHUTTER)] Trouble has occurred in the contrast shutter circuitry. Consult your dealer.
[INTAKE AIR TEMP.SENSOR]
Trouble has occurred in the sensor used to detect intake air temperature. Consult your
dealer.
[EXHAUST AIR TEMP.SENSOR]
Trouble has occurred in the sensor used to detect exhaust air temperature. Consult your
dealer.
[BATTERY] Battery replacement is required. Consult your dealer.
[AIRFLOW SENSOR] Trouble has occurred in the sensor used to detect airow. Consult your dealer.
[FILTER UNIT]
The air lter unit is not attached. Check the attachment of the air lter unit. (x page 134)
[AIR FILTER]
There is too much dust accumulated in the air lter unit. Turn the <MAIN POWER> switch to
<OFF> (x page 46), and clean the air lter. (x page 133)
[Network status] page
Click [Status]
→
[Network status].
The current network setting status is displayed.
To Next Page
Loading...
